Husqvarna BMG 555 P Operator's Manual page 16

3. Apply a soap mixture as a spray at all lines and
connections. For soap mixture use 50% soap and
50% water.
4. If there is a leak, there will be bubbles on the lines
and the connections. Speak to an approved service
agent.
To fill the propane tank
CAUTION:
and lines each time the propane tank is filled
and/or connected to the product. Refer to
connect and disconnect the propane tank on
page 11 .
Do not fill the propane tank too much. The propane tank
can hold a maximum of 9 kg/20 lbs of propane. A full
propane tank must not weigh more than 21.8 kg/48 lbs.
If the propane tank is filled too much, frost shows on the
propane lines or on the regulator.
1. Stop the product. Refer to
page 13 .
2. Make sure that the propane tank valve is closed.
3. Remove the propane tank from the product.
4. Fill the propane tank with new propane or replace
the propane tank.
5. Install the filled/new propane tank to the product.
To connect and disconnect the propane
Refer to
tank on page 11 .
6. If the weather is cold, keep the product indoors
before use to warm up the propane tank. You can
also use a propane tank heat blanket to warm up the
propane tank.
To fill the propane tank
CAUTION:
and lines each time the propane tank is filled
and/or connected to the product. Refer to
examine the propane tank and lines on page
15 .
Do not fill the propane tank too much. The propane tank
can hold a maximum of 9 kg/20 lbs of propane. A full
propane tank must not weigh more than 21.8 kg/48 lbs.
If the propane tank is filled too much, frost shows on the
propane lines or on the regulator.
1. Stop the product. Refer to
2. Make sure that the propane tank valve is closed.
3. Remove the propane tank from the product.
4. Fill the propane tank with new propane or replace
the propane tank.
5. If the propane tank is filled too much, use a
screwdriver at the propane tank valve to release
unwanted propane. Release the propane in a safe
Propane safety on page 5 .
procedure, refer to
16
Examine the propane tank
To stop the product on
Examine the propane tank
Product liability on page 4 .
6. Install the filled/new propane tank to the product.
To connect and disconnect the propane
Refer to
tank on page 11 .
7. If the weather is cold, keep the product indoors
before use to warm up the propane tank. You can
also use a propane tank heat blanket to warm up the
propane tank.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
To
2. Loosen the dipstick and pull it out.
3. Clean the oil from the dipstick.
4. Put the dipstick in the hole for the dipstick and
tighten it.
5. Loosen and pull the dipstick out and read the oil
level.
6. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
To
1991 - 001 - 02.06.2023