Husqvarna BMG 555 P Operator's Manual page 18

11. Stop the engine and make sure that the oil filter does
not leak.
12. Do a check of the oil level.
Note:
For safe disposal of used engine oil, Refer to
Disposal on page 22 .
To change the air filters
CAUTION:
when the air filters are removed.
CAUTION:
Replace each air filter when it is necessary,
Maintenance schedule on page 14 .
refer to
Note:
When there is much dust or dirt in the work
area, more frequent maintenance can be necessary.
1. Open the cap (F) to dust ejector valve to remove
dust and water from the air filter body (C).
A
C
B
2. Unlock the 2 clamps (A) and remove the case (B).
18
Do not start the engine
Do not clean the air filters.
F
3. Remove the primary air filter (D). Remove the
secondary air filter (E).
E
D
4. Put the new air filters in the air filter body.
5. Put the case on the air filter body and lock the
clamps.
To clean the cold air intake
Note:
A dirty or blocked air intake makes the product
too hot. This can cause damage to the piston and
cylinder.
• Clean the cold air intake if it is necessary.
1991 - 001 - 02.06.2023