Husqvarna BMG 555 P Operator's Manual page 9

• Half set of diamond tools: This configuration is
applicable when a flat floor finish is not necessary.
To replace the diamond tools
WARNING:
diamond tools can become very hot.
WARNING:
protection when you replace the diamond
tools. The dust below the grinding head is
dangerous to your health.
WARNING:
when you replace the diamond tools. The
dust extractor will decrease the dust that can
cause health problems.
CAUTION:
always have the same number and type of
diamond tool segments. The height of the
diamond tool segments must be the same
on all diamond tools.
1. Stop the product. Refer to
page 13 .
WARNING:
diamond discs are not rotating.
2. Adjust the handlebar to upright position. Refer to
Handle positions on page 10 .
1991 - 001 - 02.06.2023
Use protective gloves, as
Use approved respiratory
Use the dust extractor
All the diamond tools must
To stop the product on
Make sure that the
3. Hold the handlebar and tilt the product rearward. Tilt
the product until the support bracket is on the floor.
CAUTION:
do not become damaged when you tilt
the product.
CAUTION:
thin wood below the support bracket to
prevent damage to the floor.
WARNING:
product is in a stable position before you
replace the diamond tools.
4. Remove dust with the dust extractor.
5. Use a hammer to remove the diamond tools from the
tool plate.
6. Clean the tool plate with the dust extractor.
7. Attach new diamond tools to the tool plate with a soft
hit of the hammer.
8. Carefully lift the product with the handlebar to
operation position.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
Make sure the dust hose
Put a piece of cloth or
Make sure that the
Do not use the dust
9