Table of Contents
Advertisement
11
TUNING THE CHASSIS
11.16
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
(All Six Days models)
On the upper triple clamp, there are 2 holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. This allows the handle-
bar to be mounted in the most comfortable position for the rider.
M00987-10
(All standard EXC/XC-W models)
–
Remove screws
lay it to one side.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws
Guideline
Screw, handlebar support M10
–
Position the handlebar.
M00993-11
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
15 mm (0.59 in)
3.5 mm (0.138 in)
. Take off the handlebar clamps. Remove the handlebar and
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
. Take off the handlebar supports.
.
Info
Position the left and right handlebar supports evenly.
Info
Make sure the cables and wiring are positioned correctly.
Info
Make sure the gap widths are even.
to each other.
from the center.
40 Nm
Loctite
®
(29.5 lbf ft)
and tighten evenly.
M8
20 Nm
(14.8 lbf ft)
49
243™
Advertisement
Table of Contents
