Handlebar, Controls; Handlebar Position; Adjusting The Handlebar Position; Changing The Throttle Grip - Husqvarna 701 Enduro 2017 Repair Manual

7 HANDLEBAR, CONTROLS
39
7.1 Handlebar position
The holes on the handlebar support are placed at a distance of
o
from the center.
Hole distance
o
3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. In this way, the handlebar can
be mounted in the most comfortable position for the rider.
O
V00495-10
7.2 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
A
Change the handlebar if the handlebar is damaged or bent.
Remove screws O- Take off the handlebar clamps. Remove the handlebar and
lay it to one side.
O-
•' °
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
i
Remove screws
©
Remove handlebar support
0
Position rubber bushings O and push through nuts
0
from below.
Place the handlebar support in the required position. Mount and tighten
screws
Guideline
©
©
o
(Oi
0
©—o
Loctite® 243™
Screw, handlebar support
M10 45 Nm
(33.2 Ibf ft)
Position the handlebar.
0-
Info
Make sure the cables and wiring are positioned correctly.
I
Position the handlebar clamps.
Mount screws O' but do not tighten yet.
Screw the handlebar clamps so that both parts touch at the front and tighten all
of the screws.
Guideline
V00496-10
Screw, handlebar clamp
M8
20 Nm (14.8 Ibf ft)
7.3 Changing the throttle grip
Preparatory work
- Switch off the ignition by turning the ignition key to the OFF 53 position.
- Remove the headlight mask with the headlight. p. 141)
- Remove the seat, (ii p. 82)
- Take off the side cover, (i® p. 83)