Husqvarna 701 Enduro 2017 Repair Manual page 32

6 FORK, TRIPLE CLAMP
30
Info
Sealing lip downward, open side upward.
I
Push on support ring ©.
Remove the special tool.
Sand the edges of the sliding bushings with 600-grit sandpaper; then clean and
grease the bushings.
Fork oil (SAE 4) (48601166S1) (m p. 316)
4
201715-10
Push on lower sliding bushing
0
Mount upper sliding bushing
®
© ©
nf r
_______ || ^^_B03539-12
Info
Without using a tool, pull the stack slightly apart by hand.
I
Warm up outer tube in area
o
of the lower sliding bushing.
Guideline
©
/
50 °C (122 °F)
Slide the outer tube onto the inner tube.
Hold the lower sliding bushing with the longer side of the special tool.
k
Mounting tool (T14040S) (83 p. 334)
Press the sliding bushing all the way into the outer tube.
B03537-10
Position the support ring.
Hold the seal ring with the shorter side of the special tool.
y
Mounting tool (T14040S) (83 p. 334)
&V
Press the seal ring and support ring all the way into the outer tube.
. \ ^
S
__ B03538-11
Mount lock ring
©
Info
The lock ring engages audibly.
I
©
i/
B03527-12