Assembling The Fork Legs - Husqvarna 701 Enduro 2017 Repair Manual

6 FORK, TRIPLE CLAMP
29
Mount seal ring retainer © with the washer and tighten.
Guideline
Loctite® 2701 ™ Seal ring retainer M23.5x0.75 46 Nm
(33.9 Ibf ft)
©
Unclamp the cartridge.
*.
R00025-11
Slide piston rod © into the cartridge.
Info
Check that the piston ring is correctly seated.
I
Mount spring seat
©
0
©
/ *
\
R00024-10
Clamp piston rod © with the special tool.
©
Clamping stand (T14049S) (iS p. 334)
0
Screw spring guide © all the way on.
©
/ |
Info
The nut must be firmly tightened against the stop by hand. Do not use a
tool.
I
i
©
Mount adjusting tube
©
Unclamp the piston rod. Mount the preload spacer(s).
202480-11
6.20
Assembling the fork legs
Info
When assembling, ensure that the right cartridge is mounted in the corresponding inner tube and the right adjuster is
mounted on the corresponding screw cap.
Compression damping side - screw cap with mark COMP, brake caliper holder, white adjuster.
Rebound damping side - screw cap with mark REB, no brake caliper holder, red adjuster.
I
Preparatory work
- Assemble the hydrostop unit. (81 p. 26)
Main work
- Clamp the inner tube with the axle clamp.
Guideline
©
Use soft jaws.
/
Mount the special tool.
©
Protecting sleeve (T1401) (US p. 333)
©
\
Grease and push on dust boot ©-
©
R00037-10
Lubricant (T511) (H p. 318)
Info
Always change the dust boot, seal ring, lock ring, and support ring.
Mount the sealing lip with the spring expander facing down.
I
Push on lock ring
©
Grease and push on seal ring
©
Lubricant (T511) (Ei p. 318)