Table of Contents
Advertisement
9 SHOCK ABSORBER, SWINGARM
65
Info
The floating piston must be positioned at exactly this point when the rod
is fully extended; otherwise, damage will occur during compression of the
shock absorber.
I
Remove the special tool.
Remove adapter Q from connection
©
of the vacuum pump.
—
i A
!
Info
Hold the damper so that the filling port is at the highest point.
0
I
O
i'
\>
0
Remove the adapter.
Mount and tighten screw
0
Guideline
&
Filling port screw
M10x1
14 Nm (10.3 Ibf ft)
201283-10
L.
9.22
Filling the damper with nitrogen
Screw in screw O by approx. 2 rotations but do not tighten.
0
Info
The piston rod is fully extended.
I
/i
201282-10
Clamp special tool in the vise.
©
I
Nitrogen filling tool (T170S1) (H p. 335)
0
I*-,-
Connect the special tool to the pressure regulator of the filling cylinder.
Filling gas - nitrogen
Adjust
pressure
regulator.
Guideline
Gas pressure
10 bar (145 psi)
201281-10
Position the damper in the special tool.
The hexagonal part of the tap handle
o
engages in the hexagon socket of
the filling port screw.
Open filler tap ©.
Fill the damper for at least 15 seconds.
Guideline
Gas pressure
10 bar (145 psi)
Info
Watch the pressure regulator dial.
Make sure that the damper is filled to the specified pressure.
I
Close the filling port screw using tap handle
©
Close spigot © and take the damper out of the special tool.
Tighten the filling port screw.
Guideline
Screw, reservoir filling port
3 Nm (2.2 Ibf ft)
M5
Mount the rubber cap of the reservoir.
Advertisement
Table of Contents
