Husqvarna 701 Enduro 2017 Repair Manual page 258

25 THROTTLE VALVE BODY
256
25.1 Performing the initialization run
Condition
The diagnostics tool is connected and running.
- Execute "Engine electronics" > "Functions" > "Delete adaptation values".
S The adaptation values are deleted.
- Program the gear position sensor. (HH p. 234)
- Switch off ignition.
- Disconnect the diagnostics tool.
<n
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
- Always make sure there is sufficient ventilation when running the
engine.
- Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
A
A
401897-01
Start the engine without activating the throttle grip.
Guideline
Coolant temperature < 25 °C (< 77 °F)
Let the engine idle for at least 10 minutes (600 seconds).
Info
Do not activate the throttle grip during the initialization process.
I
Switch off the ignition after 10 minutes (600 seconds).
Info
If initialization is not completed or if the initialization process was inter­
rupted, the entire process must be restarted.
I
25.2 Resetting the engine electronics control unit
Condition
The diagnostics tool is connected and running.
Main work
- Execute "Engine electronics" > "Functions" > "Delete adaptation values".
i
05
401898-01
Finishing work
- Program the gear position sensor. (Hi p. 234)
Checking the CO adjustment using the Husqvarna Motorcycles diagnostics tool 25.3
Condition
The diagnostics tool is connected and running.
- Select "Engine electronics" > "Functions" > "CO adjustment when idling".
- Confirm the warning note using "Next".
- Check the position of the bar in the measurement range.
» The bar is positioned in the middle of the green area of the measurement
range.
i
- Quit the function using "Cancel".
The bar is not positioned in the middle of the green area of the measurement
range.
401898-01