Table of Contents
Advertisement
14 WHEELS
100
Check for lateral and radial run-out of the rims.
Axial run-out
outside of the rim joint
<1.8 mm (< 0.071 in)
Radial run-out
\
outside of the rim joint
<1.8 mm (< 0.071 in)
/
If the measured value is greater than the specified value:
- Center the rim.
»
if
/
/
m
j^k
Info
Center the rim by pulling the spoke nipple on the other side of the
rim run-out. If there is significant deformation, change the rim.
I
o
Correct the spoke tension.
7
o
<s>
400998-01
_
14.7
Front wheel
14.7.1
Removing the front wheel
Preparatory work
-
Raise the motorcycle with a lift stand. (US p. 11)
Main work
-
Press the brake caliper onto the brake disc by hand in order to push back the
brake pistons.
1
(
Info
Make sure that you do not press the brake caliper against the spokes
when pushing back the brake pistons.
I
-•
D00919-10
Loosen screw Q by several rotations.
Loosen screws
Press the screw O with your hand to push the wheel spindle out of the axle
clamp.
Remove screw O-
w
/*
9
4
Q
Jim
§ J
m
j
v
m
S01058-10
1
Warning
Danger of accidents Damaged brake discs reduce the braking effect.
- Always lay the wheel down in such a way that the brake disc is not
damaged.
A
m
6]
ES
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
■
Info
Do not pull the hand brake lever when the front wheel is removed.
%
I
S01057-10
Advertisement
Table of Contents
