Table of Contents
Advertisement
18 ENGINE
174
Measure axial play
©
between the connecting rod and the crankwebs using the
special tool.
0
Feeler gauge (59029041100) (m p. 322)
Connecting rod - axial clearance of
lower conrod bearing
0.30... 0.60 mm (0.0118... 0.0236 in)
-----------
If the measured value is less than the specification:
- Correct it so the dimension is equal to the specified value.
311869-10
Finishing work
-
Check the crankshaft run-out at the bearing pin. (E8 p. 174)
-
Install the drive wheel of the balancer shaft. (S® p. 174)
-
Install the crankshaft bearing inner race. (E8 p. 175)
-
Measure the axial clearance of the crankshaft and the balancer shaft, (il p. 175)
18,4.7
Checking crankshaft run-out at bearing pin
Position the crankshaft on a roller block.
Rotate the crankshaft slowly.
Check the crankshaft run-out at both bearing pins.
A
L.fi
s 0.10 mm (< 0.0039 in)
Crankshaft run-out at bearing pin
i
If the crankshaft run-out at the bearing pin is greater than the specified value:
- Align the crankshaft.
.
i
r
i
_
311870-10
18.4.8
Installing the drive wheel of the balancer shaft
Main work
- Fix the crankshaft with special tool O and
©
secure in the vise.
m.
\
©
©
Press-out plate, top (75029047050) (SS p. 326)
Press-out plate, base (75029047051) (89 p. 326)
!.
n
!
Warm the drive wheel.
Guideline
pf
V
100 °C (212 °F)
311900-10
Place the drive wheel on the crankshaft.
The dowel of the crankshaft must fit in drill hole
©
The side of the drive wheel with punch mark © must be visible after assem
bly, and the side with bevel
©
must be in contact with the crankweb.
©
©
■
VS
v f*
lO.
m
r
H
n
'"oo?
0
©
•
A
©
•-
1
311899-10
Finishing work
- Install the crankshaft bearing inner race. (®P p. 175)
Advertisement
Table of Contents
