Freewheel, Removing; Checking Freewheel; Freewheel, Installing - Husqvarna 701 Enduro 2017 Repair Manual

18 ENGINE
201
Check the gear teeth of starter motor
©
for damage and wear.
» If there is damage or wear:
- Change the starter motor.
Connect the negative cable of a 12-volt power supply to the housing of the starter motor. Connect the positive cable of the
power supply briefly with the connector of the starter motor.
» If the starter motor does not turn when the circuit is closed:
- Change the starter motor.
Change O-ring © of the starter motor.
18-4.40 freewheel, removing
Remove lock ring O-
O
$
m
311871-10
Take freewheel © out of the primary gear.
©
4
*
311872-10
18.4.41 Checking freewheel
Insert the freewheel gear O
in
the primary gear
©
, turning the primary gear
clockwise; do not twist!
Check the locking action of the freewheel gear O-
» If the primary gear does not turn clockwise or if it does not lock counterclock­
wise:
©
Remove the freewheel. (IP p. 201)
Turn the freewheel 180°.
Install the freewheel. (Bi p. 201)
311874-10
18.4.42 freewheel, installing
Thoroughly oil all parts.
Position freewheel O-
S Marking
©
is not visible after assembly.
f
©
O
311873-10