Installing The Lower Triple Clamp - Husqvarna 701 Enduro 2017 Repair Manual

6 FORK, TRIPLE CLAMP
35
Remove O-ring ©. Remove protective ring
0
Take off the lower triple clamp with the steering stem.
Remove the upper steering head bearing.
^r
A
m
.
\
m
p.
D00823-10
6.24 Installing the lower triple clamp
Main work
- Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (83 p. 318)
Insert the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
Check whether upper steering head seal O
is
correctly positioned.
Slide on protective ring
©
and O-ring
0
0—©
O
m-
T.
k
®
'■a,
X
to'
i -
©
a
■i D00834-10
Position the upper triple clamp with the handlebar.
Mount screw © but do not tighten yet.
&
L
to
D02812-10
Position the fork legs.
Bleeder screws
0
are positioned toward the front.
0
0
Info
Grooves are milled into the side of the upper end of the fork legs. The sec­
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
I
© ©
402556-11
Tighten screws
©
Guideline
nr
)
iS
Screw, bottom triple clamp M8 12 Nm (8.9 Ibf ft)
,r-
v
-
©
i
■
D02813-10