Table of Contents
Advertisement
29 SERVICE SCHEDULE
269
29.1
Additional information
Any further work that results from the required work or from the recommended work must be ordered separately and can be
invoiced separately.
Different service intervals may apply in your country, depending on the local operating conditions.
29.2
Required work
Every two years
Every year
every 20,000 km (12,400 mi)
every 10,000 km (6,200 mi)
after 1,000 km (620 mi)
Read out the fault memory using the Husqvarna Motorcycles diagnostics tool.
o
Check that the electrical system is functioning properly.
o
Change the engine oil and oil filter and clean the oil screens. (S3 p. 240)
o
Check the front brake linings. (IS p. 127)
o
Check the rear brake linings. (IS p. 132)
o
Check the brake discs. (H p. 98)
o
Check the brake lines for damage and leakage.
o
Change the front brake fluid. (18 p. 130)
Change the rear brake fluid. (IS p. 136)
Change the hydraulic clutch fluid. (13 p. 225)
Check the rear brake fluid level. (IS p. 134)
o
Check the brake fluid level of the front brake. (IS p. 129)
o
Check/correct the fluid level of the hydraulic clutch. (IS p. 225)
Check the free travel of the foot brake lever. (IS p. 134)
o
Check the shock absorber and fork for leaks. Perform a fork service and shock absorber service as
needed and depending on how the vehicle is used.
o
Clean the dust boots of the fork legs. (IS p. 16)
Check the play of the steering head bearing. (IS p. 33)
o
Check the tire condition. (IS p. 97)
o
Check the tire air pressure. (IS p. 97)
o
Check the spoke tension. (IS p. 99)
o
Check the rim run-out. (IS p. 99)
o
Check the chain, rear sprocket, engine sprocket, and chain guide. (IS p. 112)
Check the chain tension. (IS p. 110)
o
Change the fuel screen. (S3 p. 88)
o
Change the spark plugs. (IS p. 247)
Check the valve clearance. (IS p. 249)
Check the antifreeze and coolant level. (IS p. 236)
o
Check the cables for damage and routing without sharp bends.
Change the air filter. Clean the air filter box.
Check the fuel pressure. (IS p. 87)
Check the CO adjustment using the Husqvarna Motorcycles diagnostics tool. (13 p. 256)
Check the headlight setting. (IS p. 140)
o
Check that the radiator fan is functioning properly.
o
Final check: Check the vehicle for roadworthiness and take a test ride.
o
Read out the fault memory after the test ride using the Husqvarna Motorcycles diagnostics tool.
o
Make the service entry in the Husqvarna Motorcycles Dealer.net and in the Service and Warranty
Booklet.
o
o One-time interval
Advertisement
Table of Contents
