Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
37
Mount and tighten screw
©
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 Ibf ft)
Finishing work
-
Install the front fender. (ES p. 96)
-
Install the headlight mask with the headlight. (El p. 141)
-
Install the front wheel using a work stand. (El p. 102)
-
Remove the motorcycle from the work stand. (El p. 12)
-
Check that the wiring harness, throttle cables, and brake and clutch lines can
move freely and are routed correctly.
-
Check the play of the steering head bearing. (El p. 33)
-
Check the headlight setting. ( p. 140)
Changing the steering head bearing
6.25
Preparatory work
-
Switch off the ignition by turning the ignition key to the OFF £3 position.
-
Remove the headlight mask with the headlight. (81 p. 141)
-
Remove the front fender. (El p. 96)
-
Raise the motorcycle with the work stand. (BP p. 12)
-
Place a load on rear of vehicle.
S The front wheel is not in contact with the ground.
-
Remove front wheel using a work stand. (El p. 101)
-
Remove the fork legs. (El p. 17)
-
Remove the lower triple clamp. (El p. 34)
Main work
-
Remove lower bearing ring O with special tool
©
Tool bracket (58429089000) (SB p. 321)
Press-out tool (58429092000) (S3 p. 322)
©
i I
l
O
j
D00829-10
Press the new bearing ring up to the stop with special tool
©
Tool bracket (58429089000) (S3 p. 321)
-€>
■B
c
* ,
Press-in tool (58429091000) (S3 p. 321)
.*
J
il ( ( D02700-10
Remove upper bearing ring © with special tool
©
©
Tool bracket (58429089000) (S3 p. 321)
Press-out tool (58429092000) (Pi p. 322)
m
©
r
r D02701 -10
Advertisement
Table of Contents
