Preassembling The Antihopping Clutch - Husqvarna 701 Enduro 2017 Repair Manual

18 ENGINE
192
Place push rod
©
on a level surface and check it for run-out.
» If there is run-out:
- Change the push rod.
Check the length of clutch springs ©.
Clutch spring - length 31.5... 33.5 mm (1.24... 1.319 in)
» If the clutch spring length is less than the specified value:
- Change all clutch springs.
Check the contact surface of pressure cap
0
for damage and wear.
» If there is damage or wear:
- Change the pressure cap.
Check the contact surfaces of the clutch facing discs in the clutch basket
©
for wear.
Clutch basket - contact surface of clutch facing discs < 0.5 mm (< 0.02 in)
» If the contact surface is very worn:
- Change the clutch facing discs and the clutch basket.
Check needle bearing © and supporting plate © for damage and wear.
» If there is damage or wear:
- Change the needle bearing and supporting plate.
Check the intermediate clutch discs
0
for damage and wear.
» If the intermediate clutch discs are not even or are pitted:
- Change all intermediate clutch discs.
Check clutch facing discs © for discoloration and scoring.
» If there is discoloration or scoring:
- Change all clutch facing discs.
Check the thickness of clutch facing discs ©.
Clutch facing disc - thickness > 2.5 mm (> 0.098 in)
» If the clutch facing disc does not meet specifications:
- Change all clutch facing discs.
Check stepped washer
0
for damage and wear.
» If there is damage or wear:
- Change the stepped washer.
Check half washers
0
for damage and wear.
» If there is damage or wear:
- Change the half washers.
Check inner clutch hub
0
for damage and wear.
» If there is damage or wear:
- Change the inner clutch hub.
Check the outer clutch hub
0
for damage and wear.
» If there is damage or wear:
- Change the outer clutch hub.
Finishing work
- Preassemble the antihopping clutch. (S! p. 192)
18.4.31 Preassembling the antihopping clutch
Thoroughly oil the clutch facing discs.
Push the support ring O and the pretension ring
0
on to the outer clutch hub.
G
\
0
O
Info
The pretension ring must be installed so that it is flush with the inner
edge
o
on the support ring.
I
!
300123-10