Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
32
Position the spring.
Pull the spring downwards. Mount screw cap ©.
©
¥
Info
When assembling, ensure that the screw caps are correctly mounted
according to the hydrostop needles.
Rebound damping side - red hydrostop needle, screw cap with
mark REB.
Compression damping side - silver hydrostop needle, screw cap with
mark COMP.
I
201724-10
Mount the open end wrench on the hexagonal part.
Hold the open end wrench. Tighten screw cap ©.
Guideline
T
©
Screw cap on piston rod
M8x0.75
18 Nm (13.3 Ibf ft)
Special socket (T14047) (E8 p. 334)
201722-10
Push the outer tube upward.
Clamp the outer tube in the area of the lower triple clamp.
0
Clamping stand (T1403S) (Ei p. 333)
Tighten screw cap ©.
Guideline
Cartridge on outer tube
40 Nm (29.5 Ibf ft)
M51x1.5
Special socket (T14047) (H£ p. 334)
201701-11
Mount the adjuster.
Mount and tighten screw
©
Guideline
©
Screw, adjuster
M4x0.5
2.5 Nm
(1.84 Ibf ft)
i*
201700-11
Alternative 1
Turn the adjuster for rebound damping (£) (mark REB) and the adjuster for
compression damping (D (mark COMP) clockwise all the way.
Turn counterclockwise by the number of clicks corresponding to the fork
type.
Guideline
©
w -
Rebound damping
Comfort
15 clicks
201699-11
Standard
12 clicks
Sport
10 clicks
Compression damping
Comfort
15 clicks
Standard
12 clicks
Sport
10 clicks
Advertisement
Table of Contents
