Removing The Spring; Disassembling The Cartridge - Husqvarna 701 Enduro 2017 Repair Manual

6 FORK, TRIPLE CLAMP
21
Remove upper sliding bushing
©
©
©
Info
Without using a tool, pull the stack slightly apart by hand.
I
€>
Take off lower sliding bushing ©.
Take off support ring I
Take off seal ring
©
Take off lock ring Q.
Take off dust boot
©
Unclamp the fork leg.
©
\
E)
©
_
um ^
©
B03525-11
6.10 Removing the spring
Info
The steps are identical for both fork legs.
I
Preparatory work
- Disassemble the fork legs. (iJ
1
p. 19)
Main work
- Pull the spring down. Mount the open end wrench on the hexagonal part.
v
201722-11
Clamp the open end wrench in the vise. Release screw cap O but do not
remove it yet.
©
Special socket (T14047) (W p. 334)
%
201723-10
Pull the spring down. Remove the open end wrench.
Remove the screw cap.
Remove the spring with the preload spacer(s). In'
201724-11
6.11
Disassembling the cartridge
Info
The procedures are the same on both fork legs.
I
Preparatory work
- Disassemble the fork legs, (89 p. 19)
- Remove the spring. (89 p. 21)