6 FORK, TRIPLE CLAMP
18
Loosen screws ©. Take out the left fork leg.
Loosen screws ©. Take out the right fork leg.
1
iS
v*
TA
©
©
r©^L©
j
BJ
L
i
/>
D02810-10
6.7
Installing the fork legs
Main work
- Position the fork legs.
S Bleeder screws O
are
positioned toward the front.
O
O
©
Info
Grooves are milled into the side of the upper end of the fork legs. The sec
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
I
&
402556-10
Tighten screws
©
Guideline
1
Alii
Screw, top triple clamp
17 Nm (12.5 Ibf ft)
M8
S'
©
©
Tighten screws
©
Guideline
LJL
Screw, bottom triple clamp
12 Nm (8.9 Ibf ft)
M8
LL4
I
D02810-11
Position the brake line, wiring harness, and clamp. Mount and tighten screws ©.
Position the holder, and mount and tighten screws
0
Guideline
Loctite® 243™
Wheel speed sensor
screws on holder
M5
3 Nm
(2.2 Ibf ft)
©
D00917-10
©
v
#,(
Position the brake caliper.
Mount and tighten screws ©.
Guideline
f
/
Loctite® 243™
Screw, front brake caliper
M8
25 Nm
(18.4 Ibf ft)
©
r
r
\
a
r
¥W\
Route the cable for the wheel speed sensor without tension.
Position the wheel speed sensor. Mount and tighten screw
©
Guideline
©
O
D00915-11
Screw, wheel speed sensor
M6
6 Nm (4.4 Ibf ft)
Mount and tighten screw ©.
Guideline
10 Nm (7.4 Ibf ft)
Remaining screws, chassis
M6
Finishing work
-
Install the front wheel using a work stand. (K8 p. 102)
-
Remove the motorcycle from the work stand. (18 p. 12)