Checking The Heim Joint For Play; Changing The Heim Joint - Husqvarna 701 Enduro 2017 Repair Manual

9 SHOCK ABSORBER, SWINGARM
71
Grease the shaft seal rings.
Long-life grease (El p. 318)
Position collar bushings O with the shoulder facing inward.
O----- .! ©
'
■
D00775-10
Finishing work
- Install the swingarm. (El p. 68)
- Install the rear wheel using a work stand. (Hi p. 106)
- Check the chain tension. ( p. 110)
- Remove the motorcycle from the work stand. (E3
j
p. 12)
- Check the free travel of the foot brake lever. (IP p. 134)
Checking the heim joint for play 9.29
Preparatory work
- Raise the motorcycle with the work stand. (®C9 p. 12)
- Place a load on the front of the vehicle.
S The rear wheel is not in contact with the ground.
Main work
- Move the swingarm up and down.
» If there is detectable play:
- Change the heim joint. (Hi p. 71)
AT
Yj
WJ
r
' i
*>
'-TJj
D02834-10
Finishing work
- Place a load on the front of the vehicle.
- Remove the motorcycle from the work stand. ( p. 12)
Changing the heim joint 9.30
Preparatory work
- Raise the motorcycle with the work stand. (18 p. 12)
- Remove the seat. (<S p. 82)
- Take off the side cover. (Hi p. 83)
- Remove the air filter box. (KP p. 78)
- Remove the rear fairing. (Hi p. 86)
- Remove the rear left side cover. (Hi p. 85)
- Remove the rear right side cover. (Hi p. 84)
- Remove the shock absorber. (Hi p. 48)
Main work
- Clamp the shock absorber into the vise with soft jaws.
- Remove collar bushing O °f the heim joint.
a
i |
O
Pin (T120)(ra p. 332)
A
m
Turn around the shock absorber and remove collar bushing
©
of the heim joint.
w
Pin (T120) (W p. 332)
WBEMIV,'- ■ m
_______ 200577-10