Table of Contents
Advertisement
9 SHOCK ABSORBER, SWINGARM
67
Checking the swingarm bearing for play
9.25
Preparatory work
-
Raise the motorcycle with the work stand. (SP p. 12)
-
Place a load on the front of the vehicle.
S The rear wheel is not in contact with the ground.
Main work
-
Move the swingarm up and down.
» If there is detectable play:
- Change the swingarm bearing. (8J p. 69)
r\
• V
D02837-10
[Z
T
Move the swingarm from one side to the other.
» If there is detectable play:
- Change the swingarm bearing. (S3! p. 69)
t
%
V
D02838-10
Finishing work
-
Place a load on the front of the vehicle.
-
Remove the motorcycle from the work stand. (E8 p. 12)
9.26
Removing the swingarm
Preparatory work
-
Raise the motorcycle with the work stand, (li p. 12)
-
Remove the rear wheel using a work stand. (iH p. 105)
Main work
-
Take the brake caliper out of the guide and hang it to the side.
Info
Cover the components to protect them against damage.
I
D00782-10
Remove screws O and ©■
Remove the engine sprocket cover.
Open the chain. (iJ p. 114)
1
©
£
Info
Cover the components to protect them against damage.
I
K)C
m
o
Take off the chain.
R01421-10
Advertisement
Table of Contents
