Wiring Harness, Battery; Removing The Battery - Husqvarna 701 Enduro 2017 Repair Manual

Hide thumbs Also See for 701 Enduro 2017:
Table of Contents

Advertisement

15 WIRING HARNESS, BATTERY
118
15.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
-
Keep batteries out of the reach of children.
-
Wear suitable protective clothing and safety glasses.
-
Avoid contact with battery acid and battery gases.
-
Keep sparks or open flames away from the battery.
-
Only charge batteries in well-ventilated rooms.
-
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
-
Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and battery gases get into
the eyes.
A
Preparatory work
-
Switch off the ignition by turning the ignition key to the OFF £3 position.
-
Remove the seat. (S3 p. 82)
Main work
-
Pull engine electronics control unit © off of the holder and set it to one side.
W&
r
F00564-10
Remove screws
©
Pull retaining bracket
©
of the battery forward and remove it.
-
m
I IN 1
©—
ll
\
m
F00565-10
Disconnect negative cable © from the battery.
Take off positive terminal cover
©
m
r
:
m
F00566-10
Disconnect ABS connection cable
©
and positive cable © from the battery.
Lift the battery up and out.
Info
Never operate the motorcycle with a discharged battery or without a bat­
tery. In both cases, electrical components and safety devices can be dam­
aged. The vehicle will therefore no longer be roadworthy.
I
m
WaF\
*!
F00567-10 |

Advertisement

Table of Contents
loading

This manual is also suitable for:

3403054en

Table of Contents