Table of Contents
Advertisement
14 WHEELS
105
Main work
-
Check the rear hub rubber dampers. (II p. 115)
-
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
- Change the rear wheel bearing. (IS p. 107)
-
Remove spacer.
-
Clean and grease shaft seal ring Q and contact surface
o
of the spacer.
—
O
3*
©
■ e '
Long-life grease (U p. 318)
©
Insert the spacer.
M
H00937-11
Clean and grease the thread of the wheel spindle and nut
©
m—
—
m
Long-life grease (IS p. 318)
L
m
Mount the rubber damper and rear sprocket carrier in the rear wheel.
Position the rear wheel.
S The brake linings are correctly positioned.
Push the rear wheel forward as far as possible and lay the chain on the rear
sprocket.
Mount wheel spindle
©
and chain adjuster ©. Mount nut
©
, but do not
tighten it yet.
Make sure that chain adjusters ©
are
fitted correctly on adjusting screws
©
Guideline
4
JU
/<
/
.A
X
©
v
AS,
®V >
O
In order for the rear wheel to be correctly aligned, the markings on the left and
right chain adjusters must be in the same position relative to the reference
marks ©.
* rj
J
l
Info
Mount left and right chain adjusters © in the same position.
I
V00510-10
_
Tighten nut
©
Guideline
Nut, rear wheel spindle
M25x1.5
90 Nm (66.4 Ibf ft)
Position wheel speed sensor
©
in the drill hole.
Mount and tighten screw ©.
Guideline
Screw, wheel speed sensor
M6
6 Nm (4.4 Ibf ft)
-
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
Finishing work
-
Remove the motorcycle from the lift stand. (II p. 12)
-
Check the chain tension. (IS p. 110)
14.8.3
Removing the rear wheel using a work stand
Preparatory work
-
Raise the motorcycle with the work stand. (IS p. 12)
Main work
-
Press the brake caliper onto the brake disc by hand in order to push back the
brake piston.
-
Remove screw O
and
P
ul1
wheel speed sensor
©
out of the hole.
-
Remove nut
©
Remove chain adjuster ©.
-
Pull out wheel spindle
©
to the point where the chain adjuster is no longer in
contact with the adjusting screw.
m
© .-Tim
• X
v ■
lEfcS
©
OM
T00045-10
Advertisement
Table of Contents
