Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
28
Press the piston downward against the spring.
Info
Make sure the pistons do not squeeze the shims.
©
i
©-
it
Position valve Q in hydrostop needle ©. Mount and tighten the hydrostop nee
dle.
Guideline
u.
r
O
©
Hydrostop needle on piston rod
M6x0.5
8 Nm (5.9 Ibf ft)
R00039-10
• Info
I ©
- silver hydrostop needle on compression damping side.
© - red hydrostop needle on rebound damping side.
Unclamp the piston rod.
6.19
cartridge, assembling
Info
The procedures are the same on both fork legs.
I
Preparatory work
-
Assemble the seal ring retainer, (ii p. 26)
-
Assemble the piston rod. (®8 p. 27)
Main work
-
Mount and grease seal rings O and O-ring ©.
©
Q
w
\
O
Lubricant (T158) (S3 p. 318)
*
Mount and lubricate pilot bushings
0
©
Fork oil (SAE 4) (48601166S1) (S3 p. 316)
©
R00029-11
Check the length of the reservoir spring.
Guideline
O
46 mm (1.81 in)
Reservoir spring length with preload
spacer
» If the length is out of tolerance:
- Correct the preload spacers.
Position the spring with the preload spacers in the reservoir.
Position sleeve © in the reservoir.
R00028-11
Clamp cartridge with special tool.
Clamping stand (T14049S) (SP p. 334)
©
!-©
Slide reservoir
0
onto the cartridge.
/
4
m
Info
Hold the sleeve in the reservoir to prevent it from sliding out.
I
Mount lock ring
0
L
R00027-10
Advertisement
Table of Contents
