Husqvarna 701 Enduro 2017 Repair Manual page 231

19 CLUTCH
229
* ,
©
r '
' O
y
Z
&
0
©0©
©
©
0
©
.Z
«*
©
2>
o
0
o
£
R01445-10
Check clutch throw-out © for damage and wear.
» If there is damage or wear:
- Change the clutch throw-out.
Check axial bearing © for damage and wear.
» If there is damage or wear:
- Change the axial bearing.
Place the clutch push rod © on a flat surface and check for run-out.
» If there is run-out:
- Change the clutch push rod.
Check the length of clutch springs
Clutch spring - length 31.5... 33.5 mm (1.24... 1.319 in)
» If the clutch spring length is shorter than specified:
- Change all clutch springs.
Check the contact surface of pressure cap
©
for damage and wear.
» If there is damage or wear:
- Change the pressure cap.
Check the thrust surfaces of the clutch facing discs in clutch basket
©
for wear.
Clutch basket - contact surface of clutch facing discs < 0.5 mm (< 0.02 in)
» If the thrust surface exhibits excessive wear:
- Change the clutch facing discs and the clutch basket.
Check needle bearing © and supporting plate © for damage and wear.
» If there is damage or wear:
- Change the needle bearing and supporting plate.
Check intermediate clutch discs © for damage and wear.
» If the intermediate clutch discs are not level and are pitted:
- Change all intermediate clutch discs.