Table of Contents
Advertisement
22 LUBRICATION SYSTEM
239
Main work
- Check the engine oil level.
[
qj
Info
After switching off the engine, wait one minute before checking the level.
i
m
r >
D
The engine oil must be between marking
o
and marking © of the oil level
viewer.
If the engine oil level is below the © mark:
-
Add engine oil. (US p. 243)
If the engine oil level is above the
o
mark:
-
Correct the engine oil level.
S01051-10
c
Checking the engine oil pressure
22.3
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
-
Wear suitable protective clothing and safety gloves.
-
In the event of scalding, rinse the area affected immediately with lukewarm water.
A
Warning
Environmental hazard Hazardous substances cause environmental damage.
- Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Main work
- Remove screw Q.
K\
I
D02740-10
Position the banjo bolt with the connector and sealing rings. Mount and tighten
the banjo bolt.
Guideline
\
8 Nm (5.9 Ibf ft)
Banjo bolt
M10x1
Oil pressure adapter (77329006000) (§9 p. 329)
A
Connect the pressure tester to the special tool without the T-plate.
Pressure tester (61029094000) (ii p. 324)
D02741-10
Check the engine oil level, (il p. 238)
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
-
Always make sure there is sufficient ventilation when running the
engine.
-
Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
A
Start the engine and let it warm up.
Check the engine oil pressure.
Engine oil pressure
Coolant temperature: > 70 °C
(> 158 °F)
Engine speed: 1,500 rpm
> 0.4 bar (> 6 psi)
Advertisement
Table of Contents
