Changing The Parking Light Bulb; Changing The Headlight Bulb - Husqvarna 701 Enduro 2017 Repair Manual

17 LIGHTING SYSTEM, INSTRUMENTS
142
(EU)
©
Mount and tighten screws ©.
Guideline
i©
i If
Screw, headlight mask M5 5 Nm (3.7 Ibf ft)
1
Mount the brake line and wiring harness in holder
0
\
k
K00397-12
'
(US)
©
Mount and tighten screws ©.
Guideline
©
i
v
I
r 1
Screw, headlight mask 5 Nm (3.7 Ibf ft)
r
M5
Mount the brake line and wiring harness in holder
0
©
©:
S01054-11
L
Finishing work
- Check the headlight setting. (Si p. 140)
17.6 Changing the parking light bulb
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the lamp will evaporate due to the heat and be deposited on the reflector.
Clean and degrease the bulbs before mounting.
Do not touch the bulbs with your bare hands.
Preparatory work
- Switch off the ignition by turning the ignition key to the OFF 53 position.
- Remove the headlight mask with the headlight. (Si p. 141)
Main work
- Pull bulb socket O out °f the reflector.
- Pull parking light bulb
0
out of the bulb socket.
- Insert a new parking light bulb in the bulb socket.
w
)
\m as
Parking light (W5W / socket W2.1x9.5d) (S8 p. 262)
I
Insert the bulb socket in the reflector.
O
0
E00038-10
Finishing work
- Install the headlight mask with the headlight. (S3 p. 141)
- Check the headlight setting. (S3 p. 140)
Changing the headlight bulb
17.7
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the lamp will evaporate due to the heat and be deposited on the reflector.
Clean and degrease the bulbs before mounting.
Do not touch the bulbs with your bare hands.
Preparatory work
- Switch off the ignition by turning the ignition key to the OFF 53 position.
- Remove the headlight mask with the headlight. (S3 p. 141)