Husqvarna 701 Enduro 2017 Repair Manual page 248

23 IGNITION SYSTEM
246
Alternating voltage stator winding
at 4000 rpm: 20 °C (68 °F)
> 50 V
» If the indicated value does not correspond to the setpoint value:
- Change the stator.
Stator winding measurement II - check the voltage.
Measure the voltage between the specified points.
Stator, connector EN pin 1 - Stator, connector EN pin 3
V
Info
I
The results of the measurements on the individual coils must not deviate
noticeably from each other.
AC generator
Alternating voltage stator winding
at 4000 rpm: 20 °C (68 °F)
>50 V
» If the indicated value does not correspond to the setpoint value:
- Change the stator.
Stator winding measurement III - check the voltage.
Measure the voltage between the specified points.
Stator, connector EN pin 2 - Stator, connector EN pin 3
V
Info
The results of the measurements on the individual coils must not deviate
noticeably from each other.
I
AC generator
Alternating voltage stator winding
at 4000 rpm: 20 °C (68 °F)
>50 V
» If the indicated value does not correspond to the setpoint value:
- Change the stator.
Mount the positive terminal cover.
Position retaining bracket
©
Mount and tighten screws
0
Guideline
m
i
PS
■
ft
i
©
10 Nm (7.4 Ibf ft) Remaining screws, chassis M6
ISu
R01416-10
Mount engine electronics control unit Q.
O
t
i
R01415-10
Finishing work
- Mount the seat, (i® p. 83)