Checking The Damper - Husqvarna 701 Enduro 2017 Repair Manual

9 SHOCK ABSORBER, SWINGARM
57
Checking the damper 9.16
Condition
The damper has been disassembled.
- Measure the inside diameter at both ends and in the center of the damper car­
tridge.
Damper cartridge
46.10 mm (1.815 in) Diameter
v
» If the measured value is greater than the specified value:
- Change the damper cartridge.
Check the damper cartridge for damage and wear.
» If there is damage or wear:
- Change the damper cartridge.
Measure the diameter of the piston rod.
[%L
201280-10
Piston rod
> 17.95 mm (> 0.7067 in) Diameter
i
» If the specification is not reached:
- Change the piston rod.
Measure the run-out of the piston rod.
!
5«-
y
tH-} i
fC)
Piston rod
fry
300554-10
< 0.03 mm (< 0.0012 in) Run-out
» If the measured value is greater than the specified value:
- Change the piston rod.
Check the piston rod for damage and wear.
» If there is damage or wear:
- Change the piston rod.
Check the heim joint for damage and wear.
» If there is damage or wear:
- Change the heim joint.
o.
a
@0,
300460-01