Table of Contents
Advertisement
9 SHOCK ABSORBER, SWINGARM
54
Remove the spring. (H p. 54)
Dismantle the damper, (i® p. 54)
Disassemble the piston rod. (®® p. 56)
Check the damper. (SS p. 57)
Remove the heim joint. (I® p. 58)
Install the heim joint. (£98 p. 58)
Assemble the piston rod. (i® p. 59)
Assemble the damper. (£91 p. 60)
Install the spring. (£91 p. 66)
©
CD
201289-01
9.13
Removing the spring
Condition
The shock absorber has been removed.
-
Clamp the shock absorber in the vise using soft jaws for protection.
-
Measure and note spring length in preloaded state.
-
Loosen retaining ring O and the adjusting ring with the special tool.
m •
Hook wrench (T106S) (£93 p. 332)
O
Turn the retaining ring and adjusting ring until the spring is fully relieved of ten
sion.
\
201271-10
LA
Remove spring retainer
©
Take off spring with the retaining ring and adjusting ring ©.
V
©
*
■
0
©
■gal
x
201272-10
■M l*
Dismantling the damper
9.14
Preparatory work
-
Remove the spring. (£91 p. 54)
Main work
-
Establish and note the current state of the rebound damping and compression
damping.
-
Completely open the adjusters of the rebound and compression damping.
-
Remove rubber cap O of the reservoir.
-
Open screw
©
slowly.
The pressurized nitrogen escapes.
O
0
n
.
1
201273-10
Advertisement
Table of Contents
