Table of Contents
Advertisement
17 LIGHTING SYSTEM, INSTRUMENTS
143
Main work
- Turn protection cap O together with the underlying bulb socket counterclock
wise all the way and remove it.
O
A
n
1
K
E00036-10
Pull out headlight bulb ©.
Insert the new headlight bulb.
©
v S.
Headlight (H4/socket P43t) (Si p. 262)
Insert the protection cap with the bulb socket into the reflector and turn it clock
wise all the way.
n
yi
• Info
Ensure that O-ring
©
is seated properly.
E00037-10
Finishing work
-
Install the headlight mask with the headlight. (SI p. 141)
-
Check the headlight setting. (SS p. 140)
17.8
Changing the turn signal bulb (US)
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the lamp will evaporate due to the heat and be deposited on the reflector.
Clean and degrease the bulbs before mounting.
Do not touch the bulbs with your bare hands.
Remove the screw on the rear of the turn signal housing.
Carefully remove diffuser Q.
Push bulb
©
lightly into the socket, turn approx. 30° counterclockwise, and pull
it out of the socket.
O]
Li
l
©
W
Info
Do not touch the reflector with your fingers and keep it free from grease.
°
I
©
Lightly push the new lamp into the socket and turn all the way clockwise.
f S01053-10
Turn signal (RY10W/socket BAU15s) (IS p. 262)
Check that the turn signal is functioning properly.
Position the diffuser.
• Info
Insert catch
©
into
©
recess
Insert the screw and first turn counterclockwise until it engages in the thread with
a small jerk. Tighten the screw lightly.
Advertisement
Table of Contents
