Hitachi PSC-A32MN Installation And Operation Manual page 37

Operation
5.2.2.2 Display of Specified Block
1 Select the target block from the screen of "Monitor (All Groups)" or "Monitor (Block)".
Monitor (All Groups)
2 The groups in the selected block are displayed on the touchscreen. The operation status of each group is indicated by the colour
of the group, as shown below:
Green: Run
Grey: Stop
Red: Abnormal
3 Tap "Air Temp Display" to display the outside air temperature and the inlet temperature.
4 Tap "Display Condit." to display the condition of the operation.
(2)
?
N O T E
• "Block" screen may be different depending on the Control Pattern. The screen on the left corresponds to the display of Pattern A (4 Blocks × 8
Groups), as set by Control Pattern.
• The touchscreen display is put to sleep mode automatically when the touchscreen is not operated for a given length of time. Tap the screen to
wake up.
• It may take time to display the temperature.
• The inlet temperature is displayed only while operating.
29 PMML0332A rev.0 - 05/2015
(1)
Monitor (Block)
(4)
(1)
(3)