Table of Contents
Advertisement
1
Adjusting the ROPS
No Parts Required
Procedure
1. Remove the hairpin cotter pins and remove the 2 pins
from the roll bar
(Figure
1
2
5
Right Side Shown
1. Roll bar
2. Pin
2. Raise the roll bar to the upright position and install the
2 pins and secure them with the hairpin cotter pins
(Figure
4).
Note: If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove the
pins, lower the bar slowly, and secure it with the pins so
that it does not damage the hood.
2
Installing the Deck
Parts needed for this procedure:
1
Deck installation manual
Procedure
Install the deck using the Installation Manual for that deck.
4).
4
3
G004634
Figure 4
3. Hairpin cotter pin
3
Adjusting the Left Front Caster
No Parts Required
Procedure
Adjust the wheel to the outside position for 72" decks and to
the inside position for 60" and 62" decks.
4
Checking the Tire Pressure
No Parts Required
Procedure
The tires are over inflated for shipping. Therefore, release
some of the air to reduce the pressure. The correct air
pressure is 103 kPa (15 psi) in the rear tires and 172 kPa (25
psi) in the caster wheels.
15
Advertisement
Table of Contents
