Adjusting The Rollover Protection System (Rops); Adjusting The Height Of Cut - Toro Groundsmaster 4000 Operator's Manual

Adjusting the Rollover
Protection System (ROPS)
WARNING
To avoid injury or death from rollover: keep
the roll bar in the raised locked position and
use the seat belt.
Ensure that the seat is secured with the seat
latch.
WARNING
There is no rollover protection when the roll
bar is in the down position.
• Do not operate the machine on uneven
ground or on a hill side with the roll bar in
the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e., branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
Important:
Always use the seat belt when the
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
Lowering the Roll Bar
Important:
Lower the roll bar only when
necessary.
Important:
Ensure that the seat is secured with
the seat latch.
Raising the Roll Bar

Adjusting the Height of Cut

Front Mower Deck
The height of cut is adjustable from 25 to 127 mm (1
to 5 inches) in 13 mm (1/2 inch) increments. To adjust
the height of cut on the front mower deck, position
the caster-wheel axles in the upper or lower holes of
the caster forks, add or remove an equal number of
spacers from the caster forks, and secure the rear
chain to the desired hole.
29
Figure 20
Figure 21
g033136
g033137