Table of Contents
Advertisement
1070VR/1.060VR
(En/K)
6CH.INPUT playback (1070VR only)
This function allows you to pair the video signal input to the VIDEO 2 VIDEO jack with audio signals input to the 6CH.INPUT jacks.
-
@ Set the INPUT SELECTOR to VIDEO 2.
INPUT SELECTOR
(C)
@ Hold down the AUTO key for more than
2 seconds.
Lights
T
aw
'~
ose
Lt
fe
* When the receiver is set to this mode, it functions as a multi-channel
amplifier (the surround effects (etc.) cannot be activated).
* The sound of the front channel is output from the SPEAKERS A only.
The
receiver switches to the multr-channel amplitication mode auto-
matically whenever VIDEO 2 is selected.
* To undo this setting and listen to the audio signals input to the VIDEO
2 AUDIO jacks, repeat this procedure so that ""M.INPUT" goes out.
=o mri
Listening with a graphic equalizer
Hold down the DIMMER key for more
than 2 seconds.
DIMMER
C
Appears for a few seconds after the adaptor input is
turned on
When the receiver is set to this mode, the audio signals are looped
through the graphic equalizer connected to the ADAPTOR OUT and IN
Jacks on the reat panel
-)
«When the adaptor is on, the overall volume is slightly decreased
*To undo this setting, repeat this procedure to display "ADPT OFF".
Advertisement
Table of Contents
