Frequency display,
Input display,
Preset channel display,
Surround mode display
SURROUND
indicator
Band indicators
|
{
1070VR/1060VR
(En/K)
M.INPUT indicator
(1070VR only)
DSP indicator
— MEMORY indicator
Speaker indicators
'ONaTaNOOY
Faw vist,
Becopng
|
S
@ POWER key
~(i8]
Use to switch the power ON/STANDBY
© Numoric koys
© STANDBY indicator
@ LEVEL indicator
-(aZ]
Lights when the level of the signal being
'input is too hiah
© MUTE indicator
-g)
@ LOUDNESS key
—~Hk:
Use to activate the frequency weighting
network,
@ STEREO key
~-Bh
Use to cancel the surround mode.
@ PRO LOGIC key
-2E
Use to turn on the DOLBY PRO LOGIC
mode.
© DOLBY 3 STEREO key
-2ze
Use to turn on the DOLBY 3 STEREO
mode.
2
se
eA
eS
A:
SA
2
a
0
A
eh
i, ST
About the STANDBY indicator
a8:
3 STEREO indicator
winpur | MEMOR)
$.DIRECT indicator
AUTO indicator
-—|— STEREO indicator
TUNED indicstor
LOUDNESS indicator
@ DSP key
-22
Use to turn on, or switch, the DSP mode.
@ INPUT SELECTOR knob
-GR
Use to select the input sources.
@ VOLUME CONTROL knob
@ PHONES jack
Use for headphone listenina.
@ SPEAKERS A/B keys
Use to turn the speakers ON/OFF.
@ DIRECT key
-BE
Use to tune radio stations directly by nu-
merical input.
© MEMORY key
-BE
Use to store radio stations in the preset
memory.
@ AUTO key
-Z
Use to select the auto tuning mode.
@ BAND key
EE
Use to select the broadcast band.
PUT SELECTOR
VOLUME CONTROL
® TUNING keys
~ 23)
Use to tune in radio broadcasts.
@ BASS key
-an)
Use when adjusting the bass tone.
@ TREBLE key
—(2]
Use when adjusting the treble tone.
@ LEVEL CONTROL kevs
-Ga)
Use to adjust the level of the selected
tone
@ DIMMER key
Use to adjust the brightness of the display.
@® CENTER MODE key
L14.
Use to select the center mode
@ MUTE key
~(ig)
Use to mute the sound.
@ SOURCE
DIRECT
key
~e
@ AV AUX jacks
~(i0)
This unit has a STANDBY
indicatar
When
the STANDRY
indicator is lit, the unit canstimes
a small amount of pawer to preserve the
memory. This is called STANDBY mode. This mode also lets you turn the power ON using the remote control.