Table of Contents
Advertisement
1070VR/1060VR (En/K]
Make connections as shown below.
De not connoot the power cord to a wall outlet until all conncetions are completed.
Antenna terminal connections
@ Puch
laver
@ Insert
cord
© Return lever
er TRE CN TET
a
i i
a
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as
possible from the receiver, TV set, speaker cords and power
cord, and adjust the direction for best reception
FM indoor antenna
Use an optional antenna adaptor
FM outdoor antenna
FM indoor antenna
FM outdoor antenna
The supplied indoor antenna is for temporary use only. For stable
Lead the 75Q coaxial cable connected to the FM outdoor antenna
signal reception we recommend
using an outdoor antenna.
into the room and connect it to the FM 75Q terminal.
Disconnect the indoor antenna when you connect one outdoors.
FM DE-EMPHASIS / CHANNEL SPACE (Except for USA. and Canada)
The FM DE-EMPHASIS / CHANNEL SPACE switch on the rear
Xs
panelis set to the correct setting that prevails in the area to which
the unit is shipped. However, if the FM DE-EMPHASIS
/ CHAN-
NEL SPACE setting is not matched to the area where the unit is
to be used; for instance, when you move from area 1 to area 2 or
———
deollo,
vice versa, desired reception of AM
/ FM
broadcasts
is not
a
'
a
a
expected. In this case, change the FM DE-EMPHASIS / CHAN-
2oig A [a2 tone
200s
NEL SPACE setting in accordance with the area corresponding to
the table. The FM DE-EMPHASIS is switched over at the same
time.
|
Area
CHANNEL
FM
When
changing the setting of the FM DE-EMPHASIS / CHANNEL
SPACE freq.
|DE-EMPHASIS
SPACE switch, first disconnect the power cord, then reset the channel
U.S.A.. Canada and
FM:
100 kHz
space switch, connect the power cord again, and turn the power on.
1
Sauth 'arhatinan neainttle
AM:
10kHz
75 us
2
Other countries
Ae
4 ie
50 ps
L
Advertisement
Table of Contents
