Kenwood 1070VR Instruction Manual page 31

Audio video surround receiver
Hide thumbs Also See for 1070VR:
Table of Contents

Advertisement

4070VR/1060VR [En/K)
| The remote control supplied with this receiver is also capable of controlling components from a variety of manufacturers once
you register the appropriate setup codes into the remote control unit.
Refer to "Remote operation of other components" for details about the operations available for each component.
- (43)
* When registering setup codes for KENWOOD audio components which are connected to this unit by system control cords, use the
following codes to insure proper system control operation: Cassette: 7000, CD: 8099, MD: 9000.
-oL
Tu contiol utter KENWOOD curnpurients (VCRs, LD players, audiv Curpunerits not conecled willl syste control cords, etc.) follow
the procedure described below.
Low battery warning
Replace all four batteries with new ones when you notice a shortening of the distance from which the remote control will operate or if the remote control
blinks 5 times when you push a key. The remote control is designed to retain set up codes in memory while you change batteries. Failure to change
batteries after receiving the 5 blink battery warning signal may cause alt the memory to be lost (1060VR only}.
Registering
setup codes for other components.
.cuses
Find the setup code of the component to be
Component
registered.
CD player
+
Refer to the satin code lists ta find the setup eode far
the
component to be registered.
Example: To register a CD made by KENWOOD, you would
enter "8037"
+ Ifyou purchase a new component that is not covered by the
setup code list, you can use the FutureSet
upgrade feature
(1070VR only).
Re
EB Hold down the ENT key until the backlight
flashes twice and remains lit.
*At this time all inputs become available regardless of any earlier
registration.
7
Be Perform each of the following steps within
:
5 seconds.
Select the component to be registered.
Press the VIDEO, AUDIO , or TV
key repeatedly to select the de-
VIDEO key
AUDIO key
TV key
sired component.
VIDEO1 (SAT)
@ CD {CD)
@Tv1
AUDIO
[ @ VIDEO2 (LD)
'"APE/MD
@ TV2
& VIDEO3 (VCR)
(TAPE)
@ CABLE
& PHONO
= Caaiiple . Te reyister Wie Curponent cunineuted ly Wie VIDEO 1 javko,
select "VIDEO 1 (SAT)"

Advertisement

Table of Contents
loading

This manual is also suitable for:

1060vr

Table of Contents