Kenwood CS-1022 Instruction Manual page 13

CS-1022, 1021, 1012 CS-1020, 1010
CHOP: The display cannot be synchroniz-
ed with the input signal since the
chopping signal becomes the trig-
ger source.
CH1: Sweep is triggered by channel 1 signal
regardless of vertical MODE selection.
CH2: Sweep is triggered by channel 2 signal
regardless of vertical MODE selection.
LINE: Sweep is triggered by line voltage
(50/60 Hz).
EXT: Sweep is triggered by signal applied to EXT
TRIG INPUT jack @ .
@ TRIG MODE
Three-position lever switch; selects triggering mode.
AUTO: Triggered sweep = operation when _ trigger
signal is present, automatically generates
sweep (free runs) in absence of trigger signal.
NORM: Normal triggered sweep operation. No trace is
presented when a proper trigger signal is not
applied.
X-Y: . X-Y operation. Vertical input signal produces
vertical deflection (Y axis). EXT TRIG input
produces horizontal deflection (X axis).
TRIG MODE
Three-position lever switch; selects triggering mode.
AUTO: Triggered sweep operation when trigger
signal is present, automatically generates
sweep (free runs) in absence of trigger
signal.
NORM: Normal triggered sweep operation. No
trace is presented when a proper trigger
signal is not applied.
XY: X-Y operation. Channel 1 input signal pro-
duces vertical deflection (Y axis). Channel
2 input signal produces horizontal deflec-
tion (X axis).
This operates regardless vertical MODE
selection.
VARIABLE Control
Fine sweep time adjustment. In the fully clockwise
(CAL) position, the sweep time is calibrated.
VARIABLE Control
Fine sweep time adjustment. In the fully clockwise
(CAL) position, the sweep time is calibrated.
For X-Y operation, this control serves as the X axis
gain adjustment.
Q@? SWEEP TIME/DIV
Horizontal coarse sweep time selector.
Selects calibrated sweep times of 0.2 us/div to
0.5 s/div in 20 steps (CS-1010... 0.5 us/div to
0.5 s/div in 19 steps) when sweep time VARIABLE
control @ is set to CAL position (fully clockwise).
SWEEP TIME/DIV
Horizontal coarse sweep time selector.
Selects calibrated sweep times of 0.2 ys/div to 0.5 s/
div in 20 steps (CS-1021, CS-1012... 0.5 ys/div to
0.5 s/div in 19 steps) when sweep time VARIABLE
contro! @8 is set to CAL position (fully clockwise).
@) <p» POSITION, PULL x 10 MAG
Rotation adjusts horizontal position of trace. Push-pull
switch selects x 10 magnification (PULL x 10 MAG)
when pulled out; normal when pushed in.
For X-Y operation, this control serves as the X axis
position control.
<> POSITION, PULL x 10 MAG
Rotation adjusts horizontal position of trace. Push-pull
switch selects x 10 magnification (PULL x 10 MAG)
when pulled out; normal when pushed in.
13