Table of Contents
Advertisement
2. The vertical calibration coefficient is now the reference
signal's amplitude (in volts) divided by the product of
the vertical amplitude set in step 1 and the VOLTS/DIV
setting.
Using the formula:
Vertical coefficient
Voltage of the reference signal (V)
Vertical amplitude (div) x VOLTS/DIV setting
3. Remove
the reference
signal and apply the unknown
signal to the INPUT jack, using the VOLTS/DIV control
to adjust the display for easy observation.
Measure the
amplitude
of the
displayed
waveform
and
use
the
following relationship to calculate the actual amplitude
of the unknown waveform.
Using the formula:
Amplitude of the unknown signal (V)
= Vertical distance (div) x Vertical coefficient
x VOLTS/DIV setting
r
| Eee
aaa
La:
Reference signal
Waele,
Ae
el
Adjusted reference signal
[3
Atta
tt tai
FN PCE
aerateoa
\
i
ROCCO
100
90
3 div.
[EXAMPE]
For the example, the VOLTS/DIV is 1 V.
The reference signal is 2 Vrms. Using the VARIABLE, ad-
just so that the amplitude of the reference signal is 4 divi-
sions. (See Fig. 23)
Substituting the given value:
2V
Vertical coefficient = ——
=0.5
4 (div) x 1 (V)
Then measure the unknown signal and VOLTS/DIV is 5 V
and vertical amplitude is 3 divisions.
Substituting the given value:
Effective value of unknown signal = 3 (div) x 0.5 x 5(V)
=7.5 Vrms
* Period
Setting the relative sweep
coefficient
with respect to a
reference frequency signal.
Procedure:
1. Apply the reference signal to the INPUT jack, using the
VOLTS/DIV and VARIABLE to obtain an easily observed
waveform display.
Using the SWEEP TIME/DIV and VARIABLE
adjust one
cycle of the reference signal to occupy a fixed number
of scale divisions accurately. After this is done be sure
not to disturb the setting of the VARIABLE control
2. The
Sweep
(horizontal)
calibration
coefficient
is then
the period of the reference signal divided by the product
of the number of divisions used in step 1 for setup of the
reference and the setting of the SWEEP TIME/DIV con-
trol.
Using the formula:
Sweep coefficient
Period of the reference signal (sec)
horizontal width (div) x SWEEP TIME/DIV setting
3. Remove
the reference
signal and
input the unknown
signal, adjusting the SWEEP
TIME/DIV control for easy
observation.
Measure the width of one cycle in divisions and use the
following relationship to calculate the actual period.
Using the formula:
Period of unknown signal= Width of 1 cycle (div)
x sweep
coefficient x SWEEP TIME/DIV setting
|
T
Reference signal
Adjusted reference signal
100)
25
Advertisement
Table of Contents
