Table of Contents
Advertisement
ditions
could
also
pose
a safety
hazard,
which
the
ground cable will prevent.
. Always use the probe ground clips for best results. Do
not use an external ground wire in lieu of the probe
ground clips, as undesired signals may be introduced.
. Operation adjacent to equipment which produces strong
ac magnetic fields should be avoided where possible.
This
includes
such
devices
as
large power
supplies,
transformers, electric motors, etc., that are often found
in an industrial environment.
Strong magnetic shields
can exceed the practical CRT magnetic shielding limits
and result interference and distortion.
Power cord and plug type
Plug configuration
North American
120 volt/60 Hz
Rated 15 amp
(12 amp max; NEC)
7. Probe compensation
adjustment
matches the probe to
the input of the scope. For best results, compensation
of probe should be adjusted initially, then the same pro-
be always used with the input of scope. Probe compen-
sation should be readjusted whenever
a probe from a
different scope is used. (See page 19)
8. Do not depress two or more push-switches of the ver-
tical MODE switch simultaneousely. (Except ADD)
Damage
to
instrument
may
result.
(CS-1022,
CS-1021, CS-1012)
9. In X-Y operation, do not pull out the PULLx 10 MAG
switch.
If pulled
out
it, noise
may
appeare
on
the
waveform.
0.8 A, 250 V
Fast blow
AGC/3AG
Universal Europe
220 volt/50 Hz
Rated 16 amp
U.K.
240 volt/50 Hz
Rated 13 amp
Australian
240 volt/50 Hz
Rated 10 amp
0.5 A, 250 V
Fast blow
5x20 mm
0.5 A, 250 V
Fast blow
5x20 mm
0.5 A, 250 V
Fast blow
5x20 mm
North American
240 volt/60 Hz
Rated 15 amp
(12 amp max; NEC)
0.5 A, 250 V
Fast blow
AGC/3AG
Switzerland
240 voit/50 Hz
Rated 10 amp
0.5 A, 250 V
Fast blow
AGC/3AG
5x20 mm
Fig. 1 Power Input Voltage Configuration
Advertisement
Table of Contents
