Cleaning and care
Cleaning the grease filter in the dish-
washer
Depending on the detergent used,
cleaning the grease filter in a dish-
washer can cause permanent discol-
ouration to the internal surfaces of the
filter. However, this will not affect the
functioning of the grease filter in any
way.
Place the grease filter with its base
facing upwards in the lower basket.
Ensure the spray arm is not obstruc-
ted.
Use a standard household dish-
washer detergent.
Select a dishwasher programme with
a maximum wash temperature of
65 °C.
Fitting the grease filter
The grease filter has a symbol on the
front.
Insert the grease filter so that the
symbol is pointing towards the front
of the worktop.
Resetting the grease filter operating
hours counter
After cleaning the grease filter, the oper-
ating hours counter needs to be reset.
Touch the sensor for 3 seconds.
The sensor will go out.
64
Charcoal filter (only
KMDA 7676 FL-U)
Replacing the charcoal filter (only
KMDA 7676 FL-U)
The charcoal filter must be replaced
after 120 operating hours. The
sensor control will light up.
The charcoal filters listed here are suit-
able for the KMDA variants covered by
these operating instructions:
- DKF 35-P
- DKF 35-S
Remove the cover grille (see "Clean-
ing and care – Removing the cover
grille").
Remove the grease filter (see "Clean-
ing and care – Removing the grease
filter").
Remove the charcoal filter.