Installing a flush-fit hob with Plug&Play
Create the worktop cut-out. Remember to maintain the minimum safety dis-
tances (see "Installation – Safety distances").
Cut the top of the drilling template to the thickness of your worktop. Depending
on the installation depth, place the correct drilling template on top of the hous-
ing unit rear wall. Use the drilling template to create a cut-out for the Plug&Play
adapter.
Installation depth
23,8 cm
24,8 cm
1
The template is supplied with the appliance.
2
The templates can be found on the Miele homepage.
If you do not have a drilling template, see "Installation – Rear wall cut-out
without drilling template".
Solid wood, tiled and glass worktops:
Fix a wooden frame 5,5 mm below the top edge of the worktop (see "Installation
– Building-in dimensions for flush-fit installation").
Attach the sealing strip provided underneath the edge of the hob. Do not apply
the sealing strip under tension.
The Plug&Play adapter may break off.
When placing the hob on the worktop, make sure that it is not placed on top of
the Plug&Play adapter.
Connect the Plug&Play adapter to the hob and set the adapter position.
Feed the mains connection cable for the hob down through the worktop cut-out.
Plug&Play mode: remove the protective foil from the adhesive tape at the end of
the Plug&Play adapter.
Centre the hob in the cut-out.
The gap between the ceramic glass surface and the worktop must be at least
2 mm wide. This is required so that the hob can be sealed.
Plug&Play mode: align the Plug&Play adapter with the predrilled hole. Press the
adapter onto the rear wall until it sticks in place.
Drilling template num-
1
2
ber
1
3b
Installation
Adapter position
1
3
99