Table of Contents
Advertisement
•
Group 21: START/STOP
stops.
•
Group 22: ACCEL/DECEL
rate of acceleration and deceleration.
•
Group 23: SPEED CONTROL
control.
•
Group 25: CRITICAL SPEEDS
speed ranges.
•
Group 26: MOTOR CONTROL
variables.
•
Group 29: MAINTENANCE TRIG
trigger points.
•
Group 30: FAULT FUNCTIONS
responses.
•
Group 31: AUTOMATIC RESET
automatic resets.
•
Group 32: SUPERVISION
•
Group 33: INFORMATION
•
Group 34: PANEL DISPLAY
panel display.
•
Group 35: MOTOR TEMP MEAS
overheating detection and reporting.
•
Group 36: TIMED FUNCTIONS
•
Group 37: USER LOAD CURVE
load curves.
•
Group 40: PROCESS PID SET 1
control operation mode for the drive.
•
Group 41: PROCESS PID SET 2
control operation mode for the drive.
•
Group 42: EXT / TRIM PID
PID.
•
Group 45: ENERGY SAVING
calculation and optimization of energy savings.
•
Group 51: EXT COMM MODULE
for external fieldbus communication module (FBA).
•
Group 52: PANEL COMM
panel communication.
•
Group 53: EFB PROTOCOL
embedded fieldbus communication protocol.
166
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
ACH550-01 User's Manual
– Defines how the motor starts and
– Defines ramps which control the
– Defines variables for speed
– Defines critical speeds or
– Defines motor control
– Defines usage levels and
– Defines faults and
– Defines conditions for
– Defines supervision for signals.
– Contains software information.
– Defines the content for control
– Defines motor
– Defines timed functions.
– Defines user adjustable
– Defines a process PID
– Defines a process PID
– Defines parameters for External
- Defines the setup of
– Defines set-up variables
– Defines set-up variables for
– Defines set-up variables for
Parameter listing and descriptions
Advertisement
Table of Contents
