Table of Contents
Advertisement
30
en | Installing a pendant arm mount
5
10. Make the appropriate connections for PoE, 24VAC ±10%/ 36VDC ± 10%, alarms, audio.
Note: For non-IR models: If you connect fiber to the camera, then connect only 24VAC ± 10%
or 36VDC ± 10% power input to the camera. Do not connect PoE.
For IR models: If you connect fiber to the camera, connect PoE, but do not connect the
Ethernet cable. Alternately power the camera with 36VC ± 10% power or 24VAC ± 10% from
a non Bosch power supply. See Recommendations for 24 VAC Power Supply.
2023-09-29 | V06 | F.01U.410.315
Ground wire metal spade- Ground wire
of wall arm mount connects here by
plugging into the metal spade attached
to the screw
Note: Only applies to wall arm + PSU
mounts.
10
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
Ethernet cable 3/4 in. (20mm) NPS
Fitting to electrically grounded metal
conduit. Continues inside the Power
box through the arm mount to the
camera
Bosch Security Systems
Advertisement
Table of Contents
