Table of Contents
Advertisement
76
en | Troubleshooting
Notice!
A factory default deletes all camera settings including passwords, network settings, and
i
image settings.
Complete the following sequence of steps only if you have no other option to restore
operation to the camera.
Steps to complete a hardware reset for all camera models
1.
2.
3.
4.
5.
Caution!
Make sure to use a non-electrical conductive tool to push the reset button. There is a risk of
!
electric shock.
6.
7.
8.
9.
11.17
Rebooting the unit
Reboot the unit
After a Factory Default or firmware update, reboot the unit if:
–
OR
–
4
–
OR
–
2023-09-29 | V06 | F.01U.410.315
Apply power to the camera.
Find the IP address of the camera.
Log on to the camera using the web browser. (Note: You can use Configuration
Manager to identify the IP address.)
Find the hardware reset area on the camera. (Refer to the figure below to find the reset
button or terminal for your camera model.)
Push and hold the reset button for more than 8 seconds.
Let the camera complete a self-check.
Find the IP address again.
Access the camera using the web browser.
Set the initial service-level password for the camera.
You cannot connect to the unit in the Web browser.
Configuration Manager or BVMS or similar software identifies the unit as "Videojet
Generic".
Reboot the unit using one of the following methods:
In the web browser, type the IP address and then /reset (without any punctuation).
Press the Enter key.
In Configuration Manager, right-click the IP address and click Restart.
Installation Manual
AUTODOME 7100i│AUTODOME 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
