Hardware Installation Procedures; Installation Of The Inp Pca - HP 3000 Series Installation And Service Manual

Installation
2-5. HARDWARE INSTALLATION PROCEDURES
2-6. Installation of the INP PCA
Install the INP PCA as follows:
a. Ensure that all peA switches are properly configured. (Refer
to paragraph 2-4.)
b. Turn off the power.
en
the HP 3000 Ser ies 30, set the POWER swi tch (located on
the front of the HP 3000/30 mainframe, as shown in figure
2-2) to the OFF pos i tion •
On the HP 3000 Series 33, set the PROCESSOR switch (located
on the side panel beneath the desk-top of the HP 3000/33
mainframe, as shown in figure 2-3) to the OFF position.
I-CAUTION
I
All power must be
~ff
when in-
serting or remov1ng any device
or card in the system.
c. Open the door of the I/O section card cage on the back of the
HP 3000/30 or HP 3000/33 mainframe.
d. Insert the INP PCA board into a vacant card cage slot within
the "device" range (color coded blue).
On the HP 3000 Series 30, the INP can be installed in any
convenient slot in the range of 6 through
15
where the HP-
IB ribbon cable will reach all needed connectors. (The
recommended slots for the INP in a typical installation are
slots 9 and 10.)
On the HP 3000 Series 33, the INP can be installed in any
convenient slot in the range of 14 through 24.
e. Record the location of the INP PCA in the configuration sec-
tion of the System Support Log.
f. Connect the INP to the General I/O Channel (GIC) by attaching
the HP-IB Ribbon Cable (part no. 30020-60008 or optional part
no. 8120-2846) to the INP PCA connector J3.
2-6