Table of Contents
Advertisement
Equipment
Required
Installation
Overview
The
minimum
equipment required for a SCSI bus system using the HP
1G343B SCSI Bus Preprocessor consists of the following:
•
HP 1630A/D/G or HP 1631A/D Logic Analyzer;
•
HP 10269A/B General Purpose Probe Interface;
•
HP 10343B Bus Preprocessor;'
•
HP 9121D/S or HP 9122D/S 35-inch flexible disc drive;
•
One HP-IB cable;
•
One BNC cable; and
•
This operating manual.
1. Install the HP 10343B SCSI Bus Preprocessor in the HP 10269A/B
General Purpose Probe Interface (see page 2-5).
2. Select the appropriate bus mode (Single-Ended or Differential) on the
front panel of the HP 10343B (see page 2-7).
3. Select the parity setting on the HP 10343B that matches your system
(see page 2-7).
4. Connect a BNC cable from the ACCESSORY POWER output on the
rear panel of the logic analyzer to the ACCESSORY POWER input on
the HP 10269A/B.
SCSI Bus Preprocessing
2-2
Advertisement
Table of Contents
