Connecting the
HP 10343B to
the Bus
Shielded Cables
Device 1
■ a
[
Terminator
There are two types of connectors on the front panel (see figure 2-4).
•
Two 50 Pin D-Shell shielded type; and
•
One 50 Pin (dual rows of 25 Pins) connector of .100 inch spacing
(nonshielded).
The user daisy chains the shielded connectors so both of them are used
together. This is accomplished by the following steps:
1. Turn off the power to your bus system and logic analyzer.
2. Disconnect one end of a cable from your bus system and connect it to
one of the shielded connectors on the HP 10343B.
3. Connect the shielded cable supplied with the HP 10343B from the other
shielded connector on the HP 10343B to your bus system.
4. Turn on the bus and logic analyzer.
Figure 2-3. Connecting to the SCSI Bus
SCSI Bus Preprocessing
2-11