Table of Contents
Advertisement
1
Introduction
Your HP Metal Jet S100 system consists of the print station, the build unit, the powder management
station, and the powder removal station. This guide describes the use of the powder management
station.
Documentation
Full documentation is available for your product.
The following documents are available:
●
Site preparation guide
●
Introductory information
●
User guide (this document)
●
Legal information
●
Limited warranty
Product usage requirements
The products, services, and consumables are provided subject to various conditions.
●
The customer agrees to use only HP-branded consumables and HP-certified powders in the HP
product, and understands that use of any consumables other than HP consumables may cause
serious product functionality and/or safety issues, including, but not limited to those outlined in the
user guide. The customer agrees not to use the product and/or consumables for uses not permitted
by US, EU, and/or other applicable law.
●
The customer agrees not to use the product and/or consumables for the development, design,
manufacture, or production of nuclear weapons, missiles, chemical or biological weapons, and/or
explosives of any kind.
●
The customer agrees to comply with the connectivity requirement outlined below.
●
The customer may use firmware embedded in the product only to enable the product to function in
accordance with its published specifications.
●
The customer agrees to comply with the user guide.
●
Products, services, and/or technical data provided under these terms are for the customer's
internal use and not intended for further resale.
HP Metal Jet process
The process of building a metal part with HP Metal Jet is described schematically in the illustration
below. A detachable build unit, containing the powder bed and powder supplies, is rolled into the print
station for part production.
Introduction
1
Advertisement
Table of Contents
Troubleshooting
